FIX: SSTab Is Locked When on Modal Form Shown at Load Time (149274)


The information in this article applies to:

  • Microsoft Visual Basic Standard Edition, 32-bit, for Windows 4.0
  • Microsoft Visual Basic Professional Edition, 16-bit, for Windows 4.0
  • Microsoft Visual Basic Professional Edition, 32-bit, for Windows 4.0
  • Microsoft Visual Basic Enterprise Edition, 16-bit, for Windows 4.0
  • Microsoft Visual Basic Enterprise Edition, 32-bit, for Windows 4.0
This article was previously published under Q149274

SYMPTOMS

Showing a modal form in the Form_Load event of a different form causes any SSTab controls on the modal form to ignore all mouse and keyboard commands. This problem occurs with both the 16-bit and 32-bit SSTab OCXs.

RESOLUTION

This problem occurs only when the tab control is on a form that is shown modally during the load event of another form. To avoid this problem, either show the form non-modally, or show the form modally, but in an event other than the Form_Load event of the first form. Alternatively, one can emulate the appearance of showing the second form modally using a scheme similar to the one outlined below, although any code placed in the Form_Load event will be executed because execution will not pause when the second form is shown. This should be taken into account if code is written using this method. The following code fragment makes the first form invisible and then shows the second form. When the second form is unloaded, one line of code in the Unload event of the second form makes the first form visible again.

Sample Code
----------------

   ' On Form1
   Private Sub Form_Load()

      Form1.Visible = False
      Form2.Show

   End Sub

   ' On Form2
   Private Sub Form_Unload()

      Form1.Visible = True

   End Sub

STATUS

Microsoft has confirmed that this is a problem in the Microsoft products that are listed at the beginning of this article.

This bug was corrected in Visual Basic 5.0.

MORE INFORMATION

Steps to Reproduce Behavior

  1. Start Visual Basic 4.0. Form1 is created by default.
  2. Add a second form to the project by selecting Form from the Insert menu.
  3. Add a single SSTab to Form2. Leave all properties as default.
  4. Add this code to the Form_Load event of Form1:

       Private Sub Form_Load()
      Form2.Show vbModal
   End Sub
  5. Press F5 or select Start from the Run menu to start the application. Form2 displays, but the tab control does not respond to any mouse or keyboard commands.

REFERENCES

For additional information, please see the following article in the Microsoft Knowledge Base:

145638 FIX: Cannot Select Sheridan Tab Control from Modal Form

Modification Type:MinorLast Reviewed:3/14/2005
Keywords:kbBug kbfix kbVBp500fix KB149274
©2004 Microsoft Corporation. All rights reserved.