PRB: OCX Visible on All Pageframe Pages After Modal Form Runs (145892)


The information in this article applies to:

  • Microsoft Visual FoxPro for Windows 3.0
  • Microsoft Visual FoxPro for Windows 3.0b
This article was previously published under Q145892

SYMPTOMS

If a modal form is brought up over a form that contains an OLE Container Control on a page of a pageframe, when the modal form is closed, the OLE Container Control will be visible even when the page that contains it is not active.

WORKAROUND

For the form that runs atop the form with the OLE Container Control, set the WindowType property to 0 - Modeless.

-or-

In the Deactivate code for the pages that contain OLE Container Controls, move the OLE Container Control object off the page by setting its Left property to a high value. Move the object back to its proper position in the Activate code of the page.

Workaround One

Set the WindowType to 0 - Modeless for any forms brought up over forms that have OLE Container Controls on inactive pages.

Workaround Two

The following workaround moves the OLE Container Controls that are on inactive pages to a place outside the form boundaries, so modal forms can be used.

For the form that holds the pageframe with pages containing OLE Container Control objects, perform these steps:

  1. In the Init code of each of the OLE Container Controls, place: 
       THIS.Left=3500             && Some artificially high value
  2. In the Activate code of each page, place: 
       THIS.Olecontrol1.Left=35   && desired placement when on active page
  3. In the Deactivate code of each page, place: 
       THIS.Olecontrol1.Left=3500   && artificially high value
Each OLE Container Control will now be visible only when it is on the active page.

STATUS

Microsoft is researching this behavior and will post new information here in the Microsoft Knowledge Base as it becomes available.

MORE INFORMATION

Steps to Reproduce Behavior

  1. Create a form called Mainform.
  2. Add a command button and place the following code in its Click event: 
       DO FORM Modalfrm.
  3. Add a Pageframe.
  4. Add an OLE Container Control (such as Outline.ocx) to each of the two pages of the Pageframe.
  5. Save the form.
  6. Create a form called Modalfrm, and set its WindowType property to 1 - Modal. Save the form.
  7. Run Mainform, and press the command button to bring up Modalfrm over Mainform.
  8. Exit the modal form.
  9. Both of the Outline controls will be visible on the active page of the pageframe.

Notes

  1. If each of the pages are activated, the OLE Container Controls will again be visible only when the page that contains them is active.
  2. This does not occur if the form brought on top is not modal.
Modification Type:MajorLast Reviewed:9/30/2003
Keywords:KB145892
©2003 Microsoft Corporation. All rights reserved.