Using IPX/SPX Support Driver with Microsoft Network Client 3.0 (137850)
The information in this article applies to:
- Microsoft Network Client for MS-DOS 3.0
This article was previously published under Q137850
Microsoft Network Client for MS-DOS allows you to use Novell's IPXODI-based
IPX/SPX protocol and MLID to access Microsoft network resources.
To access both Microsoft network resources and Novell servers from other MS-
DOS-based clients, you must run multiple protocols and Novell's ODINSUP
driver (which allows you to use the Novell MLID). This configuration uses
more conventional memory than the MS-DOS Network Client 3.0 and the IPX/SPX
Support Driver.
To Configure Microsoft Network Client for MS-DOS to use the IPX/SPX Support
Driver and Novell's MLID and IPX/SPX so it can communicate on a Microsoft
NetBIOS based network:
- Install Novell's IPXODI networking support and verify it is
functioning properly.
- Run Setup from the Microsoft Network Client for MS-DOS 3.0 disks or from
the \CLIENTS\MSCLIENT\NETSETUP directory on the Windows NT Server CD-ROM
disc.
- Setup will automatically select the IPX/SPX Support Driver as both the
Network Card driver and the default protocol. Accept the defaults.
Modification Type: | Major | Last Reviewed: | 1/23/1999 |
---|
Keywords: | KB137850 |
---|
|