Mh32bit.386 Device Driver Causes MS-DOS Compatibility Mode (137405)
The information in this article applies to:
- Microsoft Windows 95
- Microsoft Windows 98
This article was previously published under Q137405 SYMPTOMS
If you install Windows 95 or Windows 98 on a computer using the MicroHouse
EZ-Driver software, Device Manager reports that some of your drives are
using MS-DOS Compatibility mode.
CAUSE
The Mh32bit.386 device driver that was installed by EZ-Driver is still
being loaded in the System.ini file. This device driver is not compatible
with the Windows protected-mode disk drivers, and is not removed by
Windows Setup.
RESOLUTION
Disable the line that loads the Mh32bit.386 device driver in the
System.ini file. To do so, follow these steps:
- Use any text editor (such as Notepad) to open the System.ini file in
the Windows folder.
- Locate the line that loads the Mh32bit.386 device driver.
- Place a semicolon (;) at the beginning of the line.
- Save and then close the System.ini file.
- Using the Ez.exe program by MicroHouse, disable the Floppy Boot
Protection option.
- Restart Windows.
MORE INFORMATION
For additional information about the Mh32bit.386 device driver, refer to
the documentation included with EZ-Driver, or contact MicroHouse.
EZ-Driver is manufactured by MicroHouse, a vendor independent of
Microsoft; we make no warranty, implied or otherwise, regarding this
product's performance or reliability.
Modification Type: | Minor | Last Reviewed: | 12/16/2004 |
---|
Keywords: | kb3rdparty kbprb KB137405 |
---|
|