RAS Does Not Function on IBM PS/Valuepoint 466DX2 Computers (135918)
The information in this article applies to:
- Microsoft Windows NT Server 3.5
- Microsoft Windows NT Server 3.51
- Microsoft Windows NT Workstation 3.5
- Microsoft Windows NT Workstation 3.51
This article was previously published under Q135918 SYMPTOMS
When you attempt to use the Windows NT Remote Access (RAS) AutoDetect
feature to detect your modem on an IBM PS/Valuepoint 466DX2 Type 6384 or
6387 computer, the auto-detection fails. After you manually configure RAS
for the correct modem and you try to dial a RAS server, RAS fails with the
error message:
Error 692: Hardware failure in port or attached device.
CAUSE
Your computer system BIOS is outdated.
According to IBM Technical Support, BIOS revisions prior to revision 68
have serial port problems that can cause the serial port initialization to
fail during a warm boot (when you press CTRL+ALT+DEL) of your computer,
thus rendering the serial ports inoperable. However, if you reboot your
computer by turning it off and on (cold boot), the problem still exists.
To check your computer system BIOS revision level:
- Cold boot your computer and immediately press the F1 key.
The CMOS Setup screen appears. - Find the six-digit BIOS version number at the bottom of the screen.
The last two digits represent the system BIOS revision level.
RESOLUTION
To resolve this problem, upgrade your computer system BIOS to revision
level 68 or later.
If your IBM PS/Valuepoint 466DX2 computer has a flash-upgradable BIOS,
download the L6JT68A.EXE file from the IBM BBS to obtain BIOS revision 68.
For additional information, contact IBM at:
BBS: (919) 517-0001
Technical Support: (800) 772-2227
| Modification Type: | Major | Last Reviewed: | 12/16/2003 |
|---|
| Keywords: | KB135918 |
|---|
|