Printing in PCL Mode from Adobe Illustrator Causes GP Fault (132851)
The information in this article applies to:
This article was previously published under Q132851 SYMPTOMS
When you print from Adobe Illustrator versions 4.0 or 4.03 to an HP printer
in PCL mode with EMF spooling enabled, you may received a general
protection fault.
CAUSE
The original entry for Adobe Illustrator is never seen by the Unidrv.dll
file; therefore, Adobe Illustrator incorrectly prints in vector mode.
RESOLUTION
To work around this behavior, do one of the following:
- Disable EMF spooling for the HP printer when printing from Adobe
Illustrator 4.0 or 4.03.
-or-
- In the [Compatibility] section of the Win.ini file, change the line that
reads
so that it reads:
Note that the module name is truncated from ILLUSTRATOR in the original
line to ILLUSTRA in the new line.
MORE INFORMATION
The third-party products discussed here are manufactured by vendors
independent of Microsoft; we make no warranty, implied or otherwise,
regarding these products' performance or reliability.
Modification Type: | Major | Last Reviewed: | 12/17/2000 |
---|
Keywords: | KB132851 |
---|
|