Quattro Pro 6.0: Problems Setting Up to NetWare drive (132656)
The information in this article applies to:
This article was previously published under Q132656 SYMPTOMS
When you set up Quattro Pro version 6.0 from disks on a computer running
Windows version 3.1 and choose a NetWare mapped network drive as the
destination drive, Windows 3.1 prompts you to choose whether to set up
Quattro Pro as a shared network installation on the server, or to set up
Quattro Pro on a local hard drive. This prompt appears just after the setup
page that asks for the installation path.
In Windows 95, this prompt does not appear, so that the program is always
set up as a single-user installation.
CAUSE
The Quattro Pro Setup program is looking for a Windows 3.x line in the
[boot] section of the System.ini file that is removed by Windows 95 Setup.
The line in the [boot] section reads as follows:
[boot]
SecondNet.drv=netware.drv
RESOLUTION
To work around the behavior, add the line
SecondNet.drv=netware.drv
to the [boot] section of the System.ini file. The addition of this line
does not seem to have any adverse effects on the proper operation of
Windows 95.
MORE INFORMATION
The third-party products discussed here are manufactured by vendors
independent of Microsoft; we make no warranty, implied or otherwise,
regarding these products' performance or reliability.
Modification Type: | Major | Last Reviewed: | 12/17/2000 |
---|
Keywords: | KB132656 |
---|
|