Incorrect Compression Message on DriveSpace Conversion Screen (121152)
The information in this article applies to:
- Microsoft MS-DOS operating system 6.22
This article was previously published under Q121152
When you press the F3 key to exit the first screen of an MS-DOS 6.22
DoubleSpace-to-DriveSpace conversion, the following dialog box is
displayed:
Quitting DriveSpace
DriveSpace is not completely set up on your system. If you quit now,
your hard disk will be unchanged; to compress it, you will need to
run DriveSpace again. To quit now, press F3. To continue
DriveSpace, press ENTER.
The dialog box suggests that you were attempting a compression rather than
a DoubleSpace-to-DriveSpace conversion. The dialog box should read as
follows:
Quitting DriveSpace
DriveSpace is not completely set up on your system. If you quit now,
your hard disk will be unchanged; to convert it, you will need to run
DriveSpace again. To quit now, press F3. To continue DriveSpace,
press ENTER.
Modification Type: | Major | Last Reviewed: | 11/21/1999 |
---|
Keywords: | KB121152 |
---|
|