Visual C++ Vers 2.0 README.WRI, Part 9 Utilities (120925)


The information in this article applies to:

  • Microsoft Visual C++ 2.0, when used with:
    • the hardware: Intel x86
This article was previously published under Q120925

SUMMARY

The information in this article is included in the documentation starting with Visual C++ 5.0. Look there for future revisions.

The following is based on the Visual C++ version 2.0 README.WRI file:

Using the Visual C++ Versions 1.5 and 2.0 Profilers

When you install the Profiler, you can enable the Visual C++ setup program to modify the [profiler] section of your TOOLS.INI. Visual C++ version 1.5 uses the same [profiler] block in TOOLS.INI to save Profiler settings. If the INIT variable already points to an existing TOOLS.INI used by Visual C++, Setup will modify the settings, preventing use of the Visual C++ version 1.5 profiler. To use both versions, you must manually save the settings in the [profiler] section of TOOLS.INI for each version and copy them into place when using a different version of the Profiler.
Modification Type:MajorLast Reviewed:10/17/2003
Keywords:KB120925
©2003 Microsoft Corporation. All rights reserved.