Scenes 2.0: Causes Divide by Zero Error Under Windows NT (120463)


The information in this article applies to:

  • Microsoft Scenes (all collections) 2.0
This article was previously published under Q120463

SYMPTOMS

When password protection is turned on while you are running Windows NT, and the screen saver is interrupted and no password is entered, Scenes pauses and then starts the screen saver. The amount of time Scenes pauses depends on the amount of time set in the Start Screen Saver After option.

This may cause the following error message:
Application Error: integer divide by 0.

RESOLUTION

Microsoft has confirmed this to be a problem in Scenes version 2.0. We are researching this problem and will post new information here in the Microsoft Knowledge Base as it becomes available.

MORE INFORMATION

If you are running Windows 3.1 or Windows for Workgroups 3.11, Scenes waits three minutes before starting the screen saver under the above conditions. Scenes will not wait the amount of time entered in the Start Screen Saver After option like it does in Windows NT.
Modification Type:MajorLast Reviewed:8/13/1999
Keywords:KB120463
©2002 Microsoft Corporation. All rights reserved.