Err Msg: Event ID 11: The Driver Detected a Controller Error.. (119299)
The information in this article applies to:
- Microsoft Windows NT Advanced Server 3.1
This article was previously published under Q119299
3.10
WINDOWS
kbhw
SYMPTOMS
When you create a stripe set with parity on a Windows NT Advanced Server
version 3.1 using an Adaptec 1542C or Adaptec 1542CF ISA SCSI controller,
data corruption may occur, and the following message may appear in the
Event Viewer:
Event ID: 11 Source: Aha154x Type: Error
Description: The driver detected a controller error on
\Device\ScsiPort0.
CAUSE
This problem occurs mainly due to the SCSI controller producing time-outs
during heavy I/O transfers. This problem may also be caused by poor cabling
or improper termination.
STATUS
Microsoft has confirmed this to be a problem in Windows NT Advanced Server
version 3.1. This problem was corrected in the latest U.S. Service Pack for
Windows NT and Windows NT Advanced Server version 3.1. For information on
obtaining the Service Pack, query on the following word in the Microsoft
Knowledge Base (without the spaces):
S E R V P A C K
MORE INFORMATION
The Adaptec 1542C and 1542CF SCSI controllers process slower as you add
devices to the card, congesting traffic on the bus. With the adapter load
generated by multiple devices, the combination of the poll rate waiting for
the adapter to become idle and the total time-out period allowed don't give
the adapter time for the last command to clear.
The third-party products discussed here are manufactured by Adaptec, a
vendor independent of Microsoft; we make no warranty, implied or otherwise,
regarding these products' performance or reliability.
| Modification Type: | Major | Last Reviewed: | 8/8/2001 |
|---|
| Keywords: | KB119299 |
|---|
|