TI MicroLaser w/EXP16ODI.COM Driver May Cause 15-Second Delay (111882)
The information in this article applies to:
- Microsoft Windows for Workgroups 3.11
This article was previously published under Q111882 SYMPTOMS
When you print a document to a Texas Instruments (TI) MicroLaser PS35 or TI
MicroLaser Plus using the PS35 printer driver, the local computer stops
responding (hangs) for approximately 15 seconds when the final pages print.
Control of the machine returns after the print job is completed.
STATUS
Microsoft has confirmed this to be a problem in Windows for Workgroups
version 3.11. We are researching this problem and will post new information
here in the Microsoft Knowledge Base as it becomes available.
WORKAROUND
If you are using a TI MicroLaser Plus and PS35 printer driver, you can work
around this problem by changing the emulation mode to HP LaserJet II, and
using the HP LaserJet II printer driver.
MORE INFORMATION
Modification Type: | Major | Last Reviewed: | 10/29/1999 |
---|
Keywords: | KB111882 |
---|
|