Running SCANDISK /ALL While a Virtual Drive Exists (108496)



The information in this article applies to:

  • Microsoft MS-DOS operating system 6.2
  • Microsoft MS-DOS operating system 6.21
  • Microsoft MS-DOS operating system 6.22

This article was previously published under Q108496

SYMPTOMS

Running SCANDISK /ALL incorrectly scans virtual drives created using the SUBST command.

STATUS

Microsoft has confirmed this to be a problem in the ScanDisk program included with MS-DOS versions 6.2, 6.21, and 6.22. We are researching this problem and will post new information here in the Microsoft Knowledge Base as it becomes available.

MORE INFORMATION

If you use drive A as a virtual drive (for example, by using the command SUBST A: C:\DOS), running SCANDISK A: results in the following error message
Drive A was created by using the SUBST or ASSIGN command and cannot be checked. To check drive A, run ScanDisk on drive C instead.
The error message recommends running ScanDisk on drive C because the physical directory actually resides on C. This is normal.

If you run SCANDISK /ALL, ScanDisk actually diagnoses the virtual drive. While this should not cause errors, Microsoft recommends that you not run SCANDISK /ALL while a virtual drive exists.

Modification Type:MajorLast Reviewed:11/25/1999
Keywords:KB108496