UltraStor Controller Stop Message Inaccessible Boot Device (106375)


The information in this article applies to:

  • Microsoft Windows NT Server 3.1
  • Microsoft Windows NT Workstation 3.1
This article was previously published under Q106375

SYMPTOMS

If you attempt to set up Windows NT 3.1 on an ESDI hard disk with the UltraStor 12f ESDI controller, you may receive the following STOP message:
Stop (hex dump)
Inaccessible_boot_device

WORKAROUND

According to UltraStor, you must upgrade the firmware to version 28001-012 and the BIOS to version 38001-010.

To order these upgrades, call UltraStor Technical Support at (510) 623-8955. If you have an EPROM burner, you can also download the micro code images from the UltraStor BBS at (510) 623-9091.

The products included here are manufactured by a vendor independent of Microsoft; we make no warranty, implied or otherwise, regarding these products' performance or reliability.
Modification Type:MajorLast Reviewed:10/29/2003
Keywords:kbHardware KB106375
©2003 Microsoft Corporation. All rights reserved.