LocalTalk Adapter Configuration Fails with U.S. Service Pack 1 (106214)



The information in this article applies to:

  • Microsoft Windows NT Advanced Server 3.1 Service Pack 1
  • Microsoft Windows NT Server 3.1 Service Pack 1

This article was previously published under Q106214

SYMPTOMS

After you update Windows NT with U.S. Service Pack 1 and attempt to add the driver for the DayStar Digital LocalTalk Adapter, or attempt to configure this adapter if it had already been installed prior to applying the patch, you will receive the following error message:
An Internal Error Occurred - Contact Technical Support

CAUSE

During installation of the driver for the DayStar Digital LocalTalk Adapter, you must specify which I/O address the adapter is using. After you select the proper address and choose OK, the above error message will be generated if U.S. Service Pack 1 has been installed. If the driver was installed under the initial release of Windows NT, and then the U.S. Service Pack 1 patch was applied, when you attempt to change the adapter's configuration through the Network application of Control Panel, the error message will also be generated.

RESOLUTION

The only resolution currently is to remove the modifications made by the U.S. Service Pack 1, and then the installation/configuration of the driver will be successful. You can do this by using the Emergency Repair Disk and doing the following:

  1. Start your system using Disk 1 - Setup Disk for Floppy Disk Installation, or the CD-ROM Installation Disk 1 if Windows NT was installed from CD-ROM.
  2. At the first blue screen, press R for Repair.
  3. When prompted to do so, insert the Emergency Repair Disk that was originally created for this computer.
  4. Reinsert Disk 1 when prompted. (This is the same disk with which you started your system.)
  5. You will see three selections. All three will be selected by default. Use the ARROW KEYS to move the selector bar and use the SPACEBAR to highlight/select or clear the options.
  6. Clear the selection of all options except "Verify Windows NT system files." This should be the only option that has an "X" in front of it. Move the selector bar to the line that says to Continue and press the ENTER key.

STATUS

Microsoft has confirmed this to be a problem in Windows NT and Windows NT Advanced Server version 3.1. We are researching this problem and will post new information here in the Microsoft Knowledge Base as it becomes available.

Modification Type:MajorLast Reviewed:10/29/2003
Keywords:kbother KB106214