Err Msg After Uncompressing: You Cannot Access Any... (105260)
The information in this article applies to:
- Microsoft MS-DOS operating system 6.2
- Microsoft MS-DOS operating system 6.22
This article was previously published under Q105260 SUMMARY
This information applies to both Microsoft DoubleSpace and Microsoft
DriveSpace. For MS-DOS 6.22, use DRVSPACE in place of DBLSPACE for commands
and filenames.
SYMPTOMS
After removing MS-DOS DoubleSpace, you may receive the following error
message:
You cannot access any DoubleSpace drives because the DoubleSpace
driver, DBLSPACE.BIN, is not installed.
CAUSE
This error is generated if DoubleSpace fails to remove any
DEVICE=C:\DOS\DBLSPACE.SYS commands from your CONFIG.SYS file. This
situation typically occurs if you have followed the sequence below.
- Installed MS-DOS 6.0.
- Installed DoubleSpace.
- Installed MS-DOS 6.2.
- Uncompressed your DoubleSpace drives.
- Removed MS-DOS 6.2.
RESOLUTION
To work around this situation, edit your CONFIG.SYS file and remove
all DEVICE=C:\DOS\DBLSPACE.SYS commands.
Modification Type: | Major | Last Reviewed: | 11/22/1999 |
---|
Keywords: | KB105260 |
---|
|