Windows NT 3.1 to HP LM/X 1.4 Long Filename Problems (105214)
The information in this article applies to:
- Microsoft Windows NT Server 3.1
- Microsoft Windows NT Workstation 3.1
- Microsoft Windows NT Advanced Server
This article was previously published under Q105214 SYMPTOMS
Microsoft Windows NT 3.1 systems cannot see any files in a directory
on a Hewlett-Packard (HP) LM/X 1.4 server if any file in the directory
contains a period (or "dot") followed by more than seven characters.
If you use the "dir" command to check the contents of the directory,
you will receive the following message:
File Not Found.
CAUSE
HP LM/X 1.4 systems negotiate to Server Message Block (SMB) Specification
Ext 2.0 (LAN Manager 1.x), which doesn't support long filenames. When
speaking this down-level protocol, Windows NT 3.1 does not set bit 4 of
Byte 9 of its SMBs. This bit is defined as follows:
flags (smb_flg) bit 4:
"When on, all paths sent to the server by the consumer are already in
the canonicalized format used by OS/2. This means that file/directory
names are in upper case, are valid characters and backslashes are used
as separators."
STATUS
A fixed, untested version of the RDR.SYS driver is available from
Microsoft Product Support Services.
Modification Type: | Major | Last Reviewed: | 11/20/2003 |
---|
Keywords: | kbHardware KB105214 |
---|
|