Using CTRL+F8 to Process Configuration Files on Host Drive (103562)



The information in this article applies to:

  • Microsoft MS-DOS operating system 6.2
  • Microsoft MS-DOS operating system 6.22

This article was previously published under Q103562
This information applies to both Microsoft DoubleSpace and Microsoft DriveSpace. For MS-DOS 6.22, use DRVSPACE in place of DBLSPACE for commands and filenames.

SUMMARY

After you press CTRL+F8 to start your system without loading the DoubleSpace component (DBLSPACE.BIN), you are given the option to process the configuration files (CONFIG.SYS and AUTOEXEC.BAT) on the host drive (if there are any).

For example, you can have configuration files on the DoubleSpace- compressed drive C and configuration files for a different configuration (such as playing games) on the host drive (such as H).

MORE INFORMATION

When you interactively boot your computer without DoubleSpace (CTRL+F8), MS- DOS interactively processes the configuration files on drive C, which are normally seen on the host drive H. If you are using CTRL+F8 to simply get the configuration files processed but you don't want to step through them, press ESC. (This basically answers yes to all additional yes/no prompts).

NOTE: Any device drivers or terminate-and-stay-resident (TSR) programs referenced in the configuration files on the host drive must also be located on the host drive (or an uncompressed drive). For example, if you have a CONFIG.SYS file on H referencing C:\DOS\HIMEM.SYS, you need to create a DOS directory on the host drive and copy HIMEM.SYS from C to H.

Modification Type:MajorLast Reviewed:11/22/1999
Keywords:KB103562