LAN Manager Workstation/Server

Introduction:
-------------
This document describes the procedure to setup Microsoft LAN Manager
Workstation/Server driver for D-Link DFE-528TX 10/100 Adapter.

Location of Driver: \MSLANMAN.DOS\DRIVERS\ETHERNET\DFE528\DFE528.DOS


Sample Configuration Files:
---------------------------
   CONFIG.SYS :

       DEVICE=C:\LANMAN.DOS\DRIVERS\PROTMAN\PROTMAN.DOS /I:C:\LANMAN.DOS
       DEVICE=C:\LANMAN.DOS\DRIVERS\ETHERNET\DFE528\DFE528.DOS


Setup Procedures:
-----------------
   Before you start with the installation process, make sure that the
   adapter is properly installed and configured. Make sure your
   Microsoft LAN Manager is properly installed.

   1. Run the appropriate Microsoft Lan Manager SETUP for computer you
      are setting up. Select "Configuration" item, select the
      <Other Driver> item (the DFE-528TX driver isn't included on the
      LAN Manager disk) and insert the DFE-528TX driver disk, specify the
      drive name of the driver disk (don't specify the path name),
      and follow the directions.

   2. When completed, reboot your computer .


NOTES:
------

    Sample PROTOCOL.INI for LAN Manager:

        [PROTMAN]
        DRIVERNAME = PROTMAN$
        DYNAMIC = YES
        PRIORITY = NETBEUI

        [NETBEUI_XIF]
        Drivername = netbeui$
        SESSIONS = 6
        NCBS = 12
        BINDINGS = "DFE528_NIF"
        LANABASE = 0

        [DFE528_NIF]
        ;
        ; DFE-528TX PROTOCOL.INI Sample Adapter
        ;
        DriverName = DFE528$
