Microsoft Network Client 3.0 for MS-DOS

Introduction:
-------------
This document describes the procedure to setup the Microsoft Network
Client for DOS driver on D-Link DFE-528TX 10/100 Adapter.

Location of Driver:   \DOSNDIS\DFE528.DOS

Sample Configuration Files:
---------------------------
  Ex1: [PROTOCOL.INI] (install creates this file)

       [network.setup]
       version=0x3110
       netcard=DFE528,1,DFE528,1
       transport=ms$ndishlp,MS$NDISHLP
       transport=ms$netbeui,MS$NETBEUI
       lana0=DFE528,1,ms$netbeui
       lana1=DFE528,1,ms$ndishlp

       [protman]
       DriverName=PROTMAN$
       PRIORITY=MS$NDISHLP

       [MS$NDISHLP]
       DriverName=ndishlp$
       BINDINGS=DFE528

       [MS$NETBEUI]
       DriverName=netbeui$
       SESSIONS=10
       NCBS=12
       BINDINGS=DFE528
       LANABASE=0

       [DFE528]
       ; DFE-528TX RPOTOCOL.INI SAMPLE
       DriverName=DFE528$

       EtherID=@006067111111  ;This keyword is used to designate a DFE-528TX
                              ;adapter by assigning its ethernet ID
                              ;when more than one adapters exist on one
                              ;system.


Installation Procedure:
-----------------------
   Before you start with the installation procedure, make sure that the
   adapter is properly installed and configured. Similarly, Make sure
   that your Microsoft Network Client is properly installed.
   (If not, The installation utility SETUP.EXE is located on Microsoft
   Network Client v3.0 for MS-DOS Disk. Run SETUP.EXE from Disk and the
   SETUP program screen will appear, and you must complete each of the
   questions. These options are specific to your needs. The installation
   procedure will transfer files to a specific directory on the client
   and modify existing configuration files to fit your specific needs.)

   1. Change to the Microsoft Network Client subdirectory, and run
      SETUP.EXE

   2. The screen will display some infomation. Press <Enter> .

   3. Responds to the screen prompts, selecting "Change Network
      Configuration",then press <Enter>.

   4. Move the highlight to "Add Adapter", press <Enter>.

   5. Select "Network adapter not shown on list below ...".

   6. Insert the DFE-528TX driver disk into floppy/CD-ROM drive, and
      specify your pathname EX. E:\DOSNDIS, then press <Enter>.

   7. Follow screen instructions to complete the process. Simply
      pressing <Enter> for each screen display will select the default
      options. Press <Enter> until you reach the display prompting you
      to reboot your system.


Installing Multiple LAN Adapters:
---------------------------------
      There are two different methods to complete it:

       To Follow Installation Procedure and add two adapter,

      (a) Under DOS mode, you can modify the EtherID or BusNo+DeviceNo
          keyword field in file PROTOCOL.INI.

      (b) Or you can also use the SETUP program and follow above
          setup procedure step 4, but move the highlight to "Change
          Setting", then press <Enter>, the screen will prompt you to
          fill EtherID value.
