APS APXBASE100E001 Advanced Printing Software for Tru64 UNIX ECO Summary

TITLE: APS APXBASE100E001 Advanced Printing Software for Tru64 UNIX ECO Summary
 
Modification Date:  27-SEP-1999
Modification Type:  New Kit

Copyright (c) Compaq Computer Corporation 1999.  All rights reserved.

OP/SYS:     Compaq Tru64 UNIX [R] V4.0D through V5.0

COMPONENT:  Advanced Printing Software (APS) V1.0

SOURCE:     Compaq Computer Corporation

ECO INFORMATION:

     ECO Kit Name:  APXBASE100E001
     ECO Kits Superseded by This ECO Kit:  None 
     ECO Kit Approximate Size:  2160 Blocks
     Kit Applies To:  Advanced Printing Software (APS) V1.0 for
                      Compaq Tru64 UNIX V4.0D, V4.0E, V4.0F and V5.0
     System/Cluster Reboot Necessary:  No
     Installation Rating:  N/A

     Kit Dependencies:

       The following remedial kit(s) must be installed BEFORE
       installation of this kit:

         None

       In order to receive all the corrections listed in this
       kit, the following remedial kits should also be installed:

         None


ECO KIT SUMMARY:

An ECO kit exists for Advanced Printing Software (APS) V1.0 on Compaq 
Tru64 UNIX [R] V4.0D through V5.0.  This kit addresses the following
problems: 

Problems addressed in APXBASE100E001:

o  Excessive error messages are written to the /var/dt/Xerrors log file 
   when pdconntf does not have X-access to the current Xsession.  

o  Local namespace file /etc/printers.conf may become corrupted if 
   multiple Advanced Printing Servers are running on the same system.  
   It may become impossible to communicate with APX processes until 
   the servers are restarted.



INSTALLATION NOTES:

This ECO applies to all Advanced Printing Software installations.  Note
also that new systems that came Factory Installed with Tru64 UNIX V4.0F
and later may have Advanced Printing Software preinstalled.  These systems
should also apply this ECO.

Installation of this ECO requires the subset APXBASE100 to have been previously
installed.  During the installation process, updated files will be replaced.
To install this ECO, use the setld command:

        # setld -l 

Once the ECO installation is completed, Compaq recommends you stop all
Advanced Printing Software processes on the system and restart them for the
changes to take effect:

        # /sbin/init.d/apx stop
        # /sbin/init.d/apx start

To remove this ECO, use setld to delete the ECO subset.  When the subset
it de-installed, the original files will be replaced.

        #  setld -d APXBASE100ECO001


All trademarks are the property of their respective owners.

Colorado Site
Georgia Site

apxbase100e001.README
apxbase100e001.CHKSUM
apxbase100e001.CVRLET_TXT
apxbase100e001.tar
apxbase100e001.CVRLET_TXT