OpenVMS VAXDRIV01_072 VAX V7.2 TUDRIVER/DUDRIVER ECO Summary

TITLE: OpenVMS VAXDRIV01_072 VAX V7.2 TUDRIVER/DUDRIVER ECO Summary
 
Modification Date:  22-NOV-2000
Modification Type:  Corrected references to OpenVMS VAX V7.1 to read
                    V7.2. 

NOTE:  An OpenVMS saveset or PCSI installation file is stored
       on the Internet in a self-expanding compressed file.
 
       For OpenVMS savesets, the name of the compressed saveset
       file will be kit_name.a-dcx_vaxexe for OpenVMS VAX or
       kit_name.a-dcx_axpexe for OpenVMS Alpha. Once the OpenVMS
       saveset is copied to your system, expand the compressed
       saveset by typing RUN kitname.dcx_vaxexe or kitname.dcx_alpexe.
 
       For PCSI files, once the PCSI file is copied to your system,
       rename the PCSI file to kitname-dcx_axpexe.pcsi, then it can
       be expanded by typing RUN kitname-dcx_axpexe.pcsi.  The resultant
       file will be the PCSI installation file which can be used to install
       the ECO.
 
Copyright (c) Compaq Computer Corporation 1999, 2000.  All rights reserved.

OP/SYS:     OpenVMS VAX

COMPONENT:  DUDRIVER
            TUDRIVER

SOURCE:     Compaq Computer Corporation

ECO INFORMATION:

     ECO Kit Name:  VAXDRIV01_072
     ECO Kits Superseded by This ECO Kit:  None
     ECO Kit Approximate Size:  180 Blocks
     Kit Applies To:  OpenVMS VAX V7.2
     System/Cluster Reboot Necessary:  Yes
     Rolling Re-boot Supported:  Yes
     Installation Rating:  INSTALL_3
                           3 - To be installed on all systems running
                               the listed versions of OpenVMS which
                               are experiencing the problems described.

     Kit Dependencies:

       The following remedial kit(s) must be installed BEFORE
       installation of this kit:

         None 

       In order to receive all the corrections listed in this
       kit, the following remedial kits should also be installed:

         None 


ECO KIT SUMMARY:

An ECO kit exists for TUDRIVER and DUDRIVER on OpenVMS VAX V7.2.
This kit addresses the following problems: 

  o  When initializing a FIBRECHANNEL (DG) device from a client, one
     of the two following errors is returned to the user (disk only,
     not tape):

       1.  INIT-F_DIAGPACK, disk is a diagnostic pack; or

       2.  INIT-W-NOBADDATA, bad block data not found on volume

     Note that an INIT of the same devices succeeds on the server.

     Image(s) affected:  [SYS$LDR]SYS$DUDRIVER.EXE


INSTALLATION NOTES:

The images in this kit will not take effect until the system is
rebooted.  If there are other nodes in the VMScluster, they must
also be rebooted in order to make use of the new image(s).

If it is not possible or convenient to reboot the entire cluster at
this time, a rolling re-boot may be performed.


All trademarks are the property of their respective owners.

Colorado Site
Georgia Site

vaxdriv01_072.README
vaxdriv01_072.CHKSUM
vaxdriv01_072.CVRLET_TXT
vaxdriv01_072.a-dcx_vaxexe
vaxdriv01_072.CVRLET_TXT