SNA_TE SNATE_E01017 DECNET/SNA Terminal Emulator V1.7 ECO Summary

TITLE: SNA_TE SNATE_E01017 DECNET/SNA Terminal Emulator V1.7 ECO Summary
 
NOTE:  An OpenVMS saveset or PCSI installation file is stored
       on the Internet in a self-expanding compressed file.
       The name of the compressed file will be kit_name-dcx_vaxexe
       for OpenVMS VAX or kit_name-dcx_axpexe for OpenVMS Alpha.
 
       Once the file is copied to your system, it can be expanded
       by typing RUN compressed_file.  The resultant file will
       be the OpenVMS saveset or PCSI installation file which
       can be used to install the ECO.
 
Copyright (c) Compaq Computer Corporation 1998.  All rights reserved.

Modification Date:  12-FEB-1999
Modification Type:  Reloading ECO kit to web site.  No technical or 
                    documentation update made.

PRODUCT:    DECnet SNA 3270 Terminal Emulator for OpenVMS V1.7

OP/SYS:     OpenVMS VAX                         
            OpenVMS Alpha 

SOURCE:     Compaq Computer Corporation

ECO INFORMATION:

     ECO Kit Name:  SNATE_E01017
     ECO Kits Superseded by This ECO Kit:  none
     ECO Kit Approximate Size: 1836 Blocks
                    Saveset A - 1836 Blocks

     Kit Applies To:  DECnet SNA 3270 Terminal Emulator for OpenVMS V1.7
                      OpenVMS VAX V6.1, V6.2, V7.0, V7.1 
                      OpenVMS Alpha V6.1, V6.2, V7.0, V7.1

     System/Cluster Reboot Necessary:  No


ECO KIT SUMMARY:

An ECO kit exists for DECNET/SNA Terminal Emulator for OpenVMS V1.7
on OpenVMS V6.1 through V7.1.  This kit addresses the following
problems: 

  o  SNATE Returns INVTRMPAR Error

	When the SET HOST/SNA command is executed from a TELNET'ed
	terminal the TE would return the following error:

	  %SNATERM-E-ACCROUFAI, error from Gateway access routine
	  -SNA-E-INVTRMPAR, invalid authterm parameter
	  -SNA-E-LENTOOLON, transmit byte count exceeds buffer length

	The maximum length of a terminal ID is 32 bytes for GAP V2.1 
	and was	being exeeded.  This has been corrected.


INSTALLATION NOTES:

This ECO kit is installed with the VMSINSTAL command procedure.         

After the installation is completed the product should be restarted          
per the User's Guide installation instructions, to make the new              
software active.                                                             

To make the terminal emulator shareable each time the system reboots,        
you must add the following line to your system startup procedure:            

                $ @SYS$STARTUP:SNATE$STARTUP 

Colorado Site
Georgia Site

snate_e01017.README
snate_e01017.CHKSUM
snate_e01017.CVRLET_TXT
snate_e01017.a-dcx_axpexe
snate_e01017.a-dcx_vaxexe