OSMS 3.3 LSTARA1033 Optical Storage Management Alpha ECO Summary
NOTE: An OpenVMS saveset or PCSI installation file is stored
on the Internet in a self-expanding compressed file.
The name of the compressed file will be kit_name-dcx_vaxexe
for OpenVMS VAX or kit_name-dcx_axpexe for OpenVMS Alpha.
Once the file is copied to your system, it can be expanded
by typing RUN compressed_file. The resultant file will
be the OpenVMS saveset or PCSI installation file which
can be used to install the ECO.
Copyright (c) Digital Equipment Corporation 1996. All rights reserved.
PRODUCT: Optical Storage Management Software for OpenVMS
(DEC OSMS)
OP/SYS: OpenVMS Alpha
SOURCE: Digital Equipment Corporation
ECO INFORMATION:
ECO Kit Name: LSTARA1033
ECO Kits Superseded by This ECO Kit: None
ECO Kit Approximate Size: 5230 Blocks
Kit Applies To: DEC OSMS V3.3
OpenVMS Alpha V6.1, V6.1-1H1, V6.1-1H2,
V6.2, V6.2-1H1
NOTE: A minimum version of OpenVMS Alpha
V6.1-1H2 is required for MSCP served
cluster configurations.
System Reboot Necessary: Yes
ECO KIT SUMMARY:
An ECO kit exists for DEC OSMS on OpenVMS Alpha V6.1 through V6.2. This
kit addresses the following problems:
Problems addressed in the LSTARA1033 Kit:
o Correction of conditions leading to volumes encountering "not ready
for I/O" errors.
o Correction of conditions leading to volumes hanging in mount
verification.
o Correction of conditions leading to volumes encountering "divide by
ZERO" errors.
o Various code changes to support logical I/O and MSCP served I/O.
o Set maximum I/O buffer size to 64512 bytes to prevent data
corruption caused by transfers greater than 64512 bytes.
o Corrected a problem where removes of cartridges from a jukebox
drive would cause the cartridge to be left in the robot and unknown
to software.
o Changed timeout of Prevent/Allow Remove command to 30 seconds.
NOTE: This was in response to a problem which caused overlapped
commands to impede use of jukeboxes during media removal.
o Return the correct byte count on partial transfers that end in
error.
o Corrected coding problem that would lead to system failures when a
start or stop unit command had to be retried.
Please refer to the Release Notes included with this ECO for additional
information.
INSTALLATION NOTES:
In order for the corrections in this kit to take effect, the system
must be rebooted.
This patch can be found at any of these sites:
Colorado Site
Georgia Site
Files on this server are as follows:
lstara1033.README
lstara1033.CHKSUM
lstara1033.CVRLET_TXT
lstara1033.a-dcx_axpexe
|
