DS500-VMS DS5VMSE01022H DECserver 500 V2.2.H for VMS ECO Summary
NOTE: An OpenVMS saveset or PCSI installation file is stored
on the Internet in a self-expanding compressed file.
The name of the compressed file will be kit_name-dcx_vaxexe
for OpenVMS VAX or kit_name-dcx_axpexe for OpenVMS Alpha.
Once the file is copied to your system, it can be expanded
by typing RUN compressed_file. The resultant file will
be the OpenVMS saveset or PCSI installation file which
can be used to install the ECO.
Copyright (c) Digital Equipment Corporation, 1996. All rights reserved.
PRODUCT: DECserver 500/550 for VMS
COMPONENT: DS5TSV.SYS
OP/SYS: OpenVMS VAX
OpenVMS Alpha
SOURCE: Digital Equipment Corporation
ECO INFORMATION:
ECO Kit Name: DS5VMSE01022H
ECO Kits Superseded by This Kit: None
ECO Kit Approximate Size: 2574 Blocks
DS5022H.A - 108 Blocks
DS5022H.B - 2466 Blocks
Kit Applies To: DECserver 500/550 V2.2.0 through V2.2.H
OpenVMS VAX V5.0 or higher
OpenVMS Alpha V6.1 or higher
System Reboot Necessary: No
Server Reboot: Yes
ECO KIT SUMMARY:
An ECO kit exists for DECserver 500/550 for VMS on OpenVMS VAX V5.0 or
higher and OpenVMS Alpha V6.1 or higher.
Problems addressed in the DS5VMSE01022H kit:
o When trying to connect to another service on a device (such as
MUXserver 320), the user gets a "Access denied" in reject message.
o Host receives "Queued Entry Deleted By Server" message.
Queued entries on the server will randomly get deleted by the
server. The entry gets deleted after the 60 second timer times
out to send a status message.
o Group codes in node database do not change after Multicast Message
change.
o Server port appears to be hung after opening both sessions on a
multisession terminal.
o Server crashes immediately after connecting to a local defined
service.
o Password would not be accepted when connecting to a protected
service.
o Multisession session appears hung after VT520 user closes a session
and tries to reopen it.
o Multisession port hangs after user continuously switches from one
session to another and typing Control C (which causes host to
send a attention slot to abort/flush sending previous data).
o System has a memory resource problem. This problem is caused by
a stackguard failure.
o Memory fills to 100% usage and buffers are full. System then
appears hung. Node limit is set to 200.
o A port hangs when a connection is made to a VAX system. Generally
on a remote port with roundrobin connection service on the modem.
o Ports are hung up in an XOFF state. They can be logged off, but
others continue to get hung up in an XOFF state
Please refer to the Release Notes included in the ECO kit for more
details.
INSTALLATION NOTES:
The system does not need to be rebooted after this kit is installed.
After the server reboots, the software revision information that is
displayed in response to the SHOW SERVER command should reflect a
version level of BL2.2.H.
This patch can be found at any of these sites:
Colorado Site
Georgia Site
Files on this server are as follows:
ds5022h.README
ds5022h.CHKSUM
ds5022h.CVRLET_TXT
ds5022h.a-dcx_axpexe
ds5022h.a-dcx_vaxexe
ds5022h.b-dcx_axpexe
ds5022h.b-dcx_vaxexe
|
