SEARCH CONTACT US SUPPORT SERVICES PRODUCTS STORE
United States    
COMPAQ STORE | PRODUCTS | SERVICES | SUPPORT | CONTACT US | SEARCH
gears
compaq support options
support home
software & drivers
ask Compaq
reference library
support forum
frequently asked questions
support tools
warranty information
service centers
contact support
product resources
parts for your system
give us feedback
associated links
.
} what's new
.
} contract access
.
} browse patch tree
.
} search patches
.
} join mailing list
.
} feedback
.
patches by topic
.
} DOS
.
} OpenVMS
.
} Security
.
} Tru64 Unix
.
} Ultrix 32
.
} Windows
.
} Windows NT
.
connection tools
.
} nameserver lookup
.
} traceroute
.
} ping
WANrouter 90/250 VR2VR2120-ECO01 ULTRIX ECO Summary

Copyright (c) Digital Equipment Corporation 1995. All rights reserved. PRODUCT: WANrouter 90/250 V1.2 OP/SYS: ULTRIX SOURCE: Digital Equipment Corporation ECO INFORMATION: ECO Kit Name: VR2VR2120-ECO01 ECO Kits Superseded by This ECO Kit: none ECO Kit Approximate Size: 11,280 Blocks Kit Applies To: RISC/ULTRIX V4.3A and above System Reboot Necessary: No ECO KIT SUMMARY: An ECO kit exists for WANrouter 90/250 V1.2 on ULTRIX V4.3A and above. This kit addresses the following problems: o Problem with failover to an X25 DA circuit: the routing circuit providing backup must be in the OFF state prior to failover. The configurator did not provide any means to set an X25 DA circuit to OFF on initialisation; therefore routers came up with the DA circuit ON. o Problem with failover to an X25 DA circuit: a router would crash if the primary circuit was re-stored. o When using a DECwanrouter 90EW, the configurator should permit the user to select whether files are loaded from the load host or Flash RAM. However, the appropriate network management commands were not included in the router's configuration file. o In some circumstances, a reset of a LAPB link on an X.25 connection would cause the WANrouter V1.2 software to crash. o After the configuration file had been loaded, occasional random crashes could occur while the WANrouter V1.2 was initializing. o The file ncl$globalsection.dat, used by NCL, was not compatible with the new network management features used with DECnet/OSI for OpenVMS Version 6.0/6.1. INSTALLATION NOTES: The system does not need to be rebooted after this kit is installed. However, the WANrouter 90/250 should be shutdown and restarted in order for all kit changes to take effect.



This patch can be found at any of these sites:

Colorado Site
Georgia Site



Files on this server are as follows:

vr2vr2120-eco01.README
vr2vr2120-eco01.CHKSUM
vr2vr2120-eco01.tar

privacy and legal statement