DECnet/OSI DNA_ECO1A032 DECnet/OSI V3.2A For Digital UNIX ECO Summary
Copyright (c) Digital Equipment Corporation 1995. All rights reserved.
PRODUCT: DECnet/OSI V3.2A for Digital UNIX[R]
OP/SYS: Digital UNIX
SOURCE: Digital Equipment Corporation
ECO INFORMATION:
ECO Kit Name: DNA_ECO1A032
ECO Kits Superseded by This ECO Kit: None
ECO Kit Approximate Size: dna_eco1a032.tar - 10,620 Blocks
5,437,440 Bytes
Kit Applies To: DECnet/OSI V3.2A for Digital UNIX
Digital UNIX V3.2
NOTE: DECnet/OSI V3.2A for Digital UNIX
must be installed before this
ECO can be installed.
System Reboot Necessary: No
ECO KIT SUMMARY:
An ECO kit exists for DECnet/OSI V3.2A for Digital UNIX on Digital UNIX
V3.2. This kit addresses the following problems.
o This ECO is for systems acting as DECdns servers. The corrections
included with this ECO greatly increase the reliability of the
server, especially on multiprocessor systems.
There are corrections in the following subsets:
+ DNABASE (DECnet/OSI Base Components)
+ DNANETMAN (DECnet/OSI Network Management)
+ DNADECDNSSRV (DECnet/OSI DECdns Server)
+ DNAPGMR (OSI Programming Tools)
INSTALLATION NOTES:
The DECnet/OSI V3.2A for Digital UNIX MUP (DNA321) must be installed
before the installation of this ECO.
NOTE: If DECnet/OSI is already installed on the system, you must run
"decnetshutdown" and delete the existing subsets before
installing the V3.2A MUP.
Use the setld utility to install the subsets in this ECO.
If this is an initial installation of DECnet/OSI, you may then
continue with the normal configuration procedure. If DECnet/OSI has
been previously installed, perform a decnetshutdown followed by a
decnetstartup to complete the installation.
[R] UNIX is a registered trademark in the United States and other
countries, licensed exclusively through X/Open Company Ltd.
Files on this server are as follows:
dna_eco1a032.README
dna_eco1a032.CHKSUM
dna_eco1a032.CVRLET_TXT
dna_eco1a032.tar
|