|
![](http://thenew.hp.com/img/s.gif) |
![Content starts here](http://thenew.hp.com/img/s.gif)
APS APXBASE100E001 Advanced Printing Software for Tru64 UNIX ECO Summary
|
TITLE: APS APXBASE100E001 Advanced Printing Software for Tru64 UNIX ECO Summary
Modification Date: 27-SEP-1999
Modification Type: New Kit
Copyright (c) Compaq Computer Corporation 1999. All rights reserved.
OP/SYS: Compaq Tru64 UNIX [R] V4.0D through V5.0
COMPONENT: Advanced Printing Software (APS) V1.0
SOURCE: Compaq Computer Corporation
ECO INFORMATION:
ECO Kit Name: APXBASE100E001
ECO Kits Superseded by This ECO Kit: None
ECO Kit Approximate Size: 2160 Blocks
Kit Applies To: Advanced Printing Software (APS) V1.0 for
Compaq Tru64 UNIX V4.0D, V4.0E, V4.0F and V5.0
System/Cluster Reboot Necessary: No
Installation Rating: N/A
Kit Dependencies:
The following remedial kit(s) must be installed BEFORE
installation of this kit:
None
In order to receive all the corrections listed in this
kit, the following remedial kits should also be installed:
None
ECO KIT SUMMARY:
An ECO kit exists for Advanced Printing Software (APS) V1.0 on Compaq
Tru64 UNIX [R] V4.0D through V5.0. This kit addresses the following
problems:
Problems addressed in APXBASE100E001:
o Excessive error messages are written to the /var/dt/Xerrors log file
when pdconntf does not have X-access to the current Xsession.
o Local namespace file /etc/printers.conf may become corrupted if
multiple Advanced Printing Servers are running on the same system.
It may become impossible to communicate with APX processes until
the servers are restarted.
INSTALLATION NOTES:
This ECO applies to all Advanced Printing Software installations. Note
also that new systems that came Factory Installed with Tru64 UNIX V4.0F
and later may have Advanced Printing Software preinstalled. These systems
should also apply this ECO.
Installation of this ECO requires the subset APXBASE100 to have been previously
installed. During the installation process, updated files will be replaced.
To install this ECO, use the setld command:
# setld -l
Once the ECO installation is completed, Compaq recommends you stop all
Advanced Printing Software processes on the system and restart them for the
changes to take effect:
# /sbin/init.d/apx stop
# /sbin/init.d/apx start
To remove this ECO, use setld to delete the ECO subset. When the subset
it de-installed, the original files will be replaced.
# setld -d APXBASE100ECO001
All trademarks are the property of their respective owners.
Files on this server are as follows:
|
»apxbase100e001.README
»apxbase100e001.CHKSUM
»apxbase100e001.CVRLET_TXT
»apxbase100e001.tar
»apxbase100e001.CVRLET_TXT
|